The methods and steps of Jinyu`s clothing embossing machine that how to use

1.Prepare mold : copper mold, will need to build a pattern or LOGO trademark carved on the copper mold, molds required neat, smooth surface.

2.Prepare Embossing Machine: the embossing machine to connect the power supply, heating temperature according to the size of the mold, the amount of glue is generally set at 170-240 degrees, the hot pressing time is also adjusted with the thickness of the product size, in general, the small LOGO in the garment pocket is set in 9-15 seconds;

3.cooling table:The temperature is set in the range of 0--10 degree.

4.Prepare the silicone:Add the color paste and a certain proportion of curing agent, stir it evenly, and send it to the Vacuum Machine stand for defoaming treatment.

5.Prepare the fabric:Non woven fabric or relatively high temperature resistant fabric can be used to glue the prepared cloth on the slide plate of the embossing machine.

6. Scraping: a hand held the mold, the other hand-held scraper, will draw a vacuum silicon rubber, fill the mold, after the uniform scraping into the vacuum platform, the glue on the mold to remove foam treatment.

7.Remove excess glue: remove the glue on the surface of the mold after the blister, and use the silicon rubber plate to scrape it.

8. glue: put the mold on the cloth surface and put them into the embossing machine, heating, pressing and shaping.

At this point, the finishing process is completed. The mold is separated from the cloth, and the mold is put on the freezing table for rapid cooling. When the temperature of the mold is reduced to about 40 degrees, the next round glue - defoaming - mold - molding...