The programming choice of the dispensing machine

The programming choice of the Dispensing Machine :
1.Programming of teaching box for dispensing machine:
The method of generating path by means of teaching and depicting the trajectory.
That is suitable for simple graphics and dies without engraving the original design.
Good environmental adaptability, hanging near the machine can be used at any time.
In the more starting point, edit coordinates and other operations, the line of sight can focus on the needle and the mold, you can blind play using the teaching box,
Easy to operate.
2.Programming of dispensing machine Logoshop:
Can directly into. Nc, .DXF, .AI, .JPG, .BMP and other file formats, you can also
use the scanner, eliminating the cumbersome teaching step.
In addition you can teach in online mode.Directly on the computer screen graphics,
easy to plan path.
Adjust parameters easy, intuitive and convenient.
So teaching box is suitable for the following cases:
1. Simple graphics programming.
2. Monitoring and processing.
3. Adjust the already programmed file.
Logoshop works for the following situations:
1. For the first time a mold, and the mold active map (scanning can be)
2. Complex graphics programming, a lot of irregular curves.